How do I turn my logo into a rubber stamp?
Upload your logo, the white background is removed automatically, the artwork is recoloured to the stamp ink and set inside a border with your text around the ring, then you download it as a transparent PNG.
How do I turn my logo into a rubber stamp? templates, ready to edit
Open the stamp maker with any of these
Every preview on this page carries a faint Estamplab watermark. Your own download does not: the editor renders your stamp again, clean, as a transparent PNG, an SVG or a PDF. See the full template library.
Four things have to happen to a logo before it works as a stamp, and doing them by hand is where most people give up. The background has to go, the artwork has to become one colour, it has to sit inside a border at the right proportion, and the whole thing has to export with transparency intact. Each of those is a step in an image editor. Here they are one upload.
What you get
- The background comes off on upload, including the near-white grey that scanned logos carry.
- The artwork is recoloured to the ink, because a full-colour logo inside a single-colour ring reads as a sticker.
- It is centred inside the border at stamp proportions, not at whatever size the file happened to be.
- Your company name, registration number or wording wraps around it as ring text.
- It exports transparent, so the line of the document still runs behind it.
- The aging control roughens the edges if you want it to look pressed rather than printed.
How to make it
- Open the stamp maker and press Upload logo.
- Choose your file. The white background is knocked out as it loads.
- Pick a border and type your wording around the ring.
- Set the ink colour, and the aging slider if you want a pressed look.
- Download it as a transparent PNG, or take the pack for the SVG and Word versions.
Questions
How do I turn my logo into a rubber stamp?
Open the stamp maker, press Upload logo and choose the file. The white background is removed as it loads. Pick a border, type your wording around the ring, set the ink colour, then download it as a transparent PNG. The whole thing takes about two minutes and designing it costs nothing.
Do I need Photoshop or a background remover first?
No, and that is the point of doing it here. Removing the background, flattening the artwork to one ink and exporting with transparency are the three steps that need an editor, and all three happen on upload.
What file should I upload?
A PNG that is already transparent gives the cleanest result because nothing has to be guessed. A JPEG works too, which is the common case, since a JPEG cannot carry transparency and is exactly why the white box appears.
Will the logo still be readable at stamp size?
A logo with fine detail or thin lettering loses it at 40mm, the same way it would on a real rubber die. The preview is at true size for that reason, so you can see it before you pay rather than after.
Can I use my company logo legally?
If the logo is yours or you are authorised to use it, yes. The tool generates artwork and claims nothing over the logo you supplied. It must not be used to reproduce a seal you have no authority to issue, which the terms set out.
How to turn a logo into a stamp?
Upload the logo, its background is knocked out, and it is redrawn in a single stamp ink so it prints like an impression rather than like a pasted graphic. Simple shapes survive this well; fine detail and gradients do not, so use a simplified version of the logo if there is one.
Estamplab is a design tool. This page describes common commercial practice rather than giving legal, tax or financial advice, and practice changes. Where a specific document matters, check the requirement with the body receiving it. Only produce a mark your own organisation or your own credentials are entitled to use.